Support material for Gnukey rev. DS
Ви не можете вибрати більше 25 тем Теми мають розпочинатися з літери або цифри, можуть містити дефіси (-) і не повинні перевищувати 35 символів.
Evangelos Rigas 8a2ce4d904 Add minimal case and photos 1 рік тому
Assembly Add minimal case and photos 1 рік тому
Case Add minimal case and photos 1 рік тому
Programmer Add 3D files for the case and programmer 1 рік тому
LICENCE.txt Add minimal case and photos 1 рік тому
README.md Add minimal case and photos 1 рік тому

README.md

Gnukey DS

Gnukey DS is a slim version of the Gnukey token. This repository contains complimentary material for the token such as the case.

Case

Inside the case folder there is:

  • a FreeCAD folder containing two models for a gnukey case (original and minimal) and
  • a stl folder with the generated stl files.

Below are the two cases side by side. Both cases are printed using the Form 2 resin printer, at the highest resolution setting (0.05 mm). cases

Adding the Gnukey PCBs into the cases, cases-pcb

Pogo pins holder

Similarly, for the pogo pin holder that is used for programming the PCBs. Below a close-up of the holder and the finished programming cable.

pogo holder cable

Licence

Copyright Evangelos Rigas 2019.

This documentation describes Open Hardware and is licensed under the CERN OHL v.1.2 or later. You may redistribute and modify this documentation under the terms of the CERN OHL v.1.2 (http://ohwr.org/cernohl). This documentation is distributed WITHOUT ANY EXPRESS OR IMPLIED WARRANTY, INCLUDING OF MERCHANTABILITY, SATISFACTORY QUALITY AND FITNESS FOR A PARTICULAR PURPOSE. Please see the CERN OHL v.1.2 for applicable conditions.